Is it possible to disable da0?

[Mark Saad]

Craig
  If the kernel hint may not work due to no media . You can try three other options . Tweak devd to stop checking the device . It’s doable but I can’t recall the details . Set a hint to stop loading the device that the mmc / sd card reader hangs off . Check pciconf to pin down its address . There are examples how to do this in the dpdk docs , they show how to do this in the case of a nic . It should apply to all devices. Lastly most vendors support turning the device off in bios or Uefi .  


---
Mark Saad | nonesuch at longcount.org

> On Aug 29, 2018, at 8:07 PM, Craig Leres <leres at freebsd.org> wrote:
> 
> I have a couple of foxconn netboxes that have SD slots that the system configures as da0. Starting with FreeBSD 11 we see a wad of syslog messages from devd every few seconds:
> 
>    Aug 29 16:57:39 xxx.lbl.gov devd: Processing event '!system=CAM subsystem=periph type=error device=da0 serial="20090516388200000" cam_status="0xcc" scsi_status=2 scsi_sense="70 02 3a 00" CDB="00 00 00 00 00 00 " '
>    Aug 29 16:57:39 xxx.lbl.gov devd: Pushing table
>    Aug 29 16:57:39 xxx.lbl.gov devd: Processing notify event
>    Aug 29 16:57:39 xxx.lbl.gov devd: Popping table
> 
> This is apparently because the slot doesn't not contain media. We don't use SD cards with these systems so I tried adding:
> 
>    hint.da.0.disabled="1"
> 
> to /boot/device.hints but /dev/da0 is still present after a reboot. Where am I going wrong?
> 
>        Craig
> % uname -a
> FreeBSD xxx.lbl.gov 11.2-RELEASE-p2 FreeBSD 11.2-RELEASE-p2 #2 r10: Wed Aug 15 09:23:29 PDT 2018 leres at steel.lbl.gov:/usr/src/sys/amd64/compile/LBLNET  amd64
> _______________________________________________
> freebsd-hackers at freebsd.org mailing list
> https://lists.freebsd.org/mailman/listinfo/freebsd-hackers
> To unsubscribe, send any mail to "freebsd-hackers-unsubscribe at freebsd.org"