etherswitchcfg - TPLINK TP-WR1043ND

[Wojciech Puchar]

>
> Can you post o/p of 'etherswitchcfg'?
> I've ran into this where port 0 is part of a different vlan.
not sure what "o/p" means but full output is

etherswitchcfg -v info
etherswitch0: Realtek RTL8366RB with 6 ports and 16 VLAN groups
etherswitch0: VLAN capabilities=0<>
port0:
         flags=0<>
         media: Ethernet autoselect (none)
         status: no carrier
port1:
         flags=0<>
         media: Ethernet autoselect (1000baseT <full-duplex,master>)
         status: active
port2:
         flags=0<>
         media: Ethernet autoselect (none)
         status: no carrier
port3:
         flags=0<>
         media: Ethernet autoselect (none)
         status: no carrier
port4:
         flags=0<>
         media: Ethernet autoselect (100baseTX <full-duplex>)
         status: active
port5:
         flags=0<>
         media: Ethernet 1000baseT <half-duplex,rxpause,txpause>
         status: active
vlangroup0:
         vlan: 1
         members 0,1,2,3,4,5
vlangroup1:
         vlan: 2
         members none
vlangroup2:
         vlan: 3
         members none
vlangroup3:
         vlan: 4
vlangroup4:
         vlan: 5
         members none
vlangroup5:
         vlan: 6
         members none
vlangroup6:
         vlan: 7
         members none
vlangroup7:
         vlan: 8
         members none
vlangroup8:
         vlan: 9
         members none
vlangroup9:
         vlan: 10
         members none
vlangroup10:
         vlan: 11
         members none
vlangroup11:
         vlan: 12
         members none
vlangroup12:
         vlan: 13
         members none
vlangroup13:
         vlan: 14
         members none
vlangroup14:
         vlan: 15
         members none
vlangroup15:
         vlan: 16
         members none



if i connect cable to port0, etherswitch shows it is connected, but no 
communication