DIR-825B1 iicbus thing

[Luiz Otavio O Souza]

Maybe you're lucky and it is just supported:
http://svnweb.freebsd.org/base/head/sys/dev/etherswitch/rtl8366/ :-) (but
i'm not sure if 's' or the 'rb' suffix matter).

Please check the TPLink 1043 kernel and hints for a setup example for this
switch.

Luiz


On 6 September 2013 15:29, Adrian Chadd <adrian at freebsd.org> wrote:

> please port it? :-P
>
>
> -adrian
>
>
> On 6 September 2013 11:18, Sean Bruno <sean_bruno at yahoo.com> wrote:
>
> > I've almost got a functional set of gpio pin hints setup now.  I seem to
> > have an unsupported device on the iicbus, probably the realtek switch
> > thing?
> >
> >
> > iicbb0: <I2C bit-banging driver> on gpioiic0
> > iicbus0: <Philips I2C bus> on iicbb0 master-only
> > iicbus0: <unknown card> at addr 0xa8
> > iic0: <I2C generic I/O> on iicbus0
> >
> > The DIR-825B1 seems to have a "rtl8366s" ethernet switch.  That needs to
> > be ported to FreeBSD.  OpenWRT seems to have a driver for it:
> >
> >
> https://dev.openwrt.org/browser/trunk/target/linux/generic/files/drivers/net/phy/rtl8366s.c
> >
> > Sean
> >
> _______________________________________________
> freebsd-embedded at freebsd.org mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-embedded
> To unsubscribe, send any mail to "freebsd-embedded-unsubscribe at freebsd.org
> "
>