"Intel Centrino Advanced-N + WiMAX 6250" doesn't work

[Tz-Huan Huang]

On Wed, Sep 7, 2011 at 21:11, Tz-Huan Huang <tzhuan at gmail.com> wrote:
> On Wed, Sep 7, 2011 at 20:34, Bernhard Schmidt <bschmidt at freebsd.org> wrote:
>> On Wed, Sep 7, 2011 at 12:10, Kevin Lo <kevlo at freebsd.org> wrote:
>>>
>>> Please try attached patch. It seems like OpenBSD added support
>>> for 6205, but I'm not sure if it works for 6250.
>
> Okay, I am re-building the kernel now,
> will report here if any news.

Well, it is no luck here. The error messages are almost the same:

http://www.csie.ntu.edu.tw/~b90093/tmp/iwn-patched-debug.txt

Here is the diff:

--- iwn-debug.txt       2011-09-07 20:56:08.724651659 +0800
+++ iwn-patched-debug.txt       2011-09-07 21:23:28.674953262 +0800
@@ -24,7 +24,6 @@
 interrupt reg1=80000000 reg2=0
 iwn_notif_intr: qid 0 idx 1 flags 0 type 98(UNKNOWN INTR NOTIF/CMD) len 8
 iwn_notif_intr: qid 4 idx 1 flags 0 type 176(IWN_CMD_PHY_CALIB) len 4
-interrupt reg1=0 reg2=0
 iwn5000_query_calibration: sending calibration query
 iwn_cmd: IWN5000_CMD_CALIB_CONFIG (0x65) flags 0 qid 4 idx 2
 interrupt reg1=80000000 reg2=0
@@ -62,7 +61,6 @@
 interrupt reg1=80000000 reg2=0
 iwn_notif_intr: qid 0 idx 1 flags 0 type 98(UNKNOWN INTR NOTIF/CMD) len 8
 iwn_notif_intr: qid 4 idx 1 flags 0 type 176(IWN_CMD_PHY_CALIB) len 4
-interrupt reg1=0 reg2=0
 send calibration result idx=0 len=3964
 iwn0: iwn5000_send_calibration: could not send calibration result, error 22
 iwn0: iwn_init_locked: could not initialize hardware, error 22

Thanks,
Tz-Huan