8.0RC1: Can't mount usb stick

[Hans Petter Selasky]

On Friday 02 October 2009 13:39:46 Marten Vijn wrote:
> On Fri, 2009-10-02 at 10:25 +0200, Goran Gajic wrote:
> > Same here:
> >
> > ugen2.2: <vendor 0x1005> at usbus2 (disconnected)
> > umass0: at uhub2, port 5, addr 2 (disconnected)
> > (da0:umass-sim0:0:0:0): lost device
> > (da0:umass-sim0:0:0:0): removing device entry
> > ugen2.2: <vendor 0x1005> at usbus2
> > umass0: <vendor 0x1005 USB FLASH DRIVE, class 0/0, rev 2.00/1.10, addr 2>
> > on usbus2
> > umass0:  SCSI over Bulk-Only; quirks = 0x0000
> > umass0:1:0:-1: Attached to scbus1
> > (probe0:umass-sim0:0:0:0): TEST UNIT READY. CDB: 0 0 0 0 0 0
> > (probe0:umass-sim0:0:0:0): CAM Status: SCSI Status Error
> > (probe0:umass-sim0:0:0:0): SCSI Status: Check Condition
> > (probe0:umass-sim0:0:0:0): UNIT ATTENTION asc:28,0
> > (probe0:umass-sim0:0:0:0): Not ready to ready change, medium may have
> > changed
> > (probe0:umass-sim0:0:0:0): Retrying Command (per Sense Data)
> > da0 at umass-sim0 bus 0 target 0 lun 0
> > da0: < USB FLASH DRIVE PMAP> Removable Direct Access SCSI-0 device
> > da0: 40.000MB/s transfers
> > da0: 1968MB (4030464 512 byte sectors: 255H 63S/T 250C)
> >
> > # mount -t msdosfs /dev/da0 /mnt
> > mount_msdosfs: /dev/da0: Invalid argument
>
> _and_ booting 8.0RC-1 from a ubs-stick results in a panic.....
>

Can you try this patch:

http://perforce.freebsd.org/chv.cgi?CH=169085

--HPS