Odd hang during boot on RPI2 for 2 days now

[Jukka Ukkonen]

Continuing where I previously left with this problem...
When I set boot_verbose=1 in loader.conf I got a little
more information before the poor RPI2 simply froze.
Now the last shown line was...

random: harvesting attach, 8 bytes (4 bits) from ukbd0

If I disconnect the USB keyboard and then reconnect it,
the kernel prints the normal detach and attach messages,
once again returns back to printing the "random: ..."
line shown above, and freezes again.

--jau



On 03/04/16 16:31, Jukka Ukkonen wrote:
> 
> Hello all,
> 
> A couple of days ago I rebuilt 11-current for my RPI2.
> For some odd and still unexplained reason it started
> hanging after it had found the USB keyboard during the
> auto-configure. I have tried "svn update" a few times
> since the problem started, but apparently there has
> been no patch to this. The latest svn version which I
> have tried is 296383.
> I attach the dmesg.boot from the last known good boot.
> It shows the last known properly booting system was
> 11.0-CURRENT r296310.
> I have also marked the place where the boot now hangs
> as follows ...
> 
> ...
> kbd1 at ukbd0
> ***
> smsc0: chip 0xec00, rev. 0002
> ...
> 
> Everything before the "***" mark seems to work just fine.
> At the mark all progress stops and none of the messages
> normally seen after this point are shown.
> 
> Has something changed perhaps in a manner which could
> cause this hang?
> 
> --jau
>