What goes wrong?

[Krassimir Slavchev]

Bernd Walter wrote:
> On Tue, Feb 20, 2007 at 01:36:16PM +0100, Soeren Straarup wrote:
>   
>> On Tue, Feb 20, 2007 at 01:48:46PM +0200, Krassimir Slavchev wrote:
>>     
>>> oops. In the Makefile.inc
>>>
>>>       
>> Hmm.. None of hte 3 worked .. back to eth drawing board and investigate some
>> more.
>>     
>
> bootspi initialises SDRAM and PLL and uses it.
> It would explain bps or character errors, if your board has different
> SDRAM or xtal setup than the selected bootflavour,
> There are some other board specific points to configure correctly as
> well.
>
>   
Would you like to give us more information about these board specific 
points?
I have problems booting:

Default: /boot/kernel/kernel.gz.tramp
boot:
cmd is ''
-

The prompt moves some time and stopped.

Any ideas?

Thanks in advance
>>>> hat goes wrong when i send via serial xmodem the bootspi to the arm board
>>>> and all i get back is some unreadable chars?
>>>> I'm doing this from windows via teraterm at 115200
>>>>         
>
>