Application not working when Power OFF/ON is done while on reset its working

[Bernd Walter]

On Tue, Dec 19, 2006 at 12:51:46AM -0800, neha_makhija wrote:
> 
> hi
> 
> I am working on AT91RM9200 development board with ecos ported over it. I
> have burnt the flash with the redboot image. When i turn off the board and
> then turn it ON then the code doesnt work and doesnt show anything on the
> hyperterminal. But if i reset the board then the code is working fine.

Neither ecos nor redboot is part of FreeBSD.

Speaking of hardware - maybe the onboard reset is bad - the reset
impuls for the rm9200 needs to be very long.
But that is guessing, I just know the hardware, not your software.

> Can u please suggest me the possible reason alongwith the solution of this
> problem as soon as possible.

Ask on a ecos list, or install FreeBSD if you insist asking on a
FreeBSD list.

-- 
B.Walter                http://www.bwct.de      http://www.fizon.de
bernd at bwct.de           info at bwct.de            support at fizon.de