Matrox G450 PCI on XFree86 4.3.0
Marco Beishuizen
marco at beishuizen.info
Fri May 9 11:25:24 PDT 2003
I just upgraded my PWS600au to 4.8-RELEASE. My problem is that I
can't get X to work (I had no problems with X on 4.7-RELEASE).
After running startx my monitor gives a big red warning that my
"frequency is out of range" and that I have to "change signal
timing". I tried lots of settings in /etc/X11/XF86Config, but
even 640x480 at 8 gives the same result.
When running xf86config I gave exactly the same answers as with
previous versions of XFree and had never any problems before,
using the G400 driver.
What can I do to make X work?
Marco
--
Write-Protect Tab, n.:
A small sticker created to cover the unsightly notch carelessly
left by disk manufacturers. The use of the tab creates an error
message once in a while, but its aesthetic value far outweighs the
momentary inconvenience.
-- Robb Russon
More information about the freebsd-alpha
mailing list