AE_NO_HARDWARE_RESPONSE problems

[Andrew Thompson]

On Wed, Jun 30, 2004 at 12:49:18PM -0700, Nate Lawson wrote:
> On Tue, 29 Jun 2004, Andrew Thompson wrote:
> > On Mon, Jun 28, 2004 at 01:44:47PM -0700, Nate Lawson wrote:
> > > On Mon, 28 Jun 2004, Andrew Thompson wrote:
> > > > On my HP Omnibook 6000 I get the following right after boot
> > > >
> > > > etc... I changed the loop on line 829 of acpi_ec.c from 1000 to 10000 and
> > > > everything seems to be working fine. Is this a valid fix or will it cause
> > > > problems elsewhere? One issue I can see is holding Giant for this length of
> > > > time.
> > > >
> > >
> > > Try the code I just committed instead.
> > >
> >
> > It doesnt seem to have changed. Here is the tail of the dmesg, link to
> > full one below. Thanks.
> 
> Ok, I think I found one other problem.  Please try this patch (booted,
> tested):
> 

It seems to be working perfectly. The errors would normally pop up a few
seconds after the login prompt. I also tried setting
thermal.polling_rate to 1 to work the EC a bit more, no errors. :)


thanks.