Iwill onboard AIC-7895, linux, termination

[Vlad Vul]

Hi, aic7xxx.

I have Iwill motherboard BS100 with onboard SCSI AIC-7895
(Ultra Wide 40?)
and Atlas III HDD 160 LVD with no any termination.
68 pins bus (I tryed 2 different)

On HDD TERMPWR is on, and NO INTERNAL TERMINATION,
host adapter has internal automatic termination.

It works with parity errors, but then I swith on terminator to bus,
SCSI BIOS says "SCSI termination not found" and dont loading.

Now I boot it with floppy in such mode:

adapter chennel A (7id)---------------- Disk (0id)
                                         |
                                         |
adapter chennel B (6id)------------------/
                 |
                 Terminator

It is only mode it works. Have you Ideas for improvement?

I tryed 2 linux flavours and 2.2 and 2.4 kernels with same result, so
qweers is in hardware/BIOS



-- 
С уважением,
 Vlad                          mailto:vul at mail.ru


To Unsubscribe: send mail to majordomo at FreeBSD.org
with "unsubscribe aic7xxx" in the body of the message