Adaptec 2930U

[Richard Reina]

I am having some trouble getting the aic7xxx driver working.  I used 
make menuconfig and selected "M" for the aic7xxx driver and for SCSI 
tape support ( since my ultimate goal is to get my new DAT drive 
installed ) SCSI support was already built into my original kernel. 
 Because I do not want to do a full install until I get the the tape 
drive installed and back up my data, I did the following.

make clean
make dep
make modules
make modules_install

When I try
# modprobe aic7xxx

I get several error messages similar to this:

unresolved symbol scsi_partsize_7e31a8

Module-HOWTO says that this is caused because "CONFIG_MODVERSIONS" is 
enabled.  However, it also says that if your kernel was originally 
configured with CONFIG_MODVERSIONS you must enable this option when you 
add modules.  It does not tell you how you can get around the unresolved 
symbols problem.  If any on can help I would greatly appreciate it as I 
am anxious to get the tape drive installed so that I can back up my data.

Richard




To Unsubscribe: send mail to majordomo at FreeBSD.org
with "unsubscribe aic7xxx" in the body of the message