Re: (slicers and linux ports) was: Re: running FreeBSD on Notebook

On Fri, May 6, 2022 at 9:59 PM Steve O'Hara-Smith <steve@sohara.org> wrote:
> On Fri, 6 May 2022 13:17:41 -0600
> Gary Aitken <freebsd@dreamchaser.org> wrote:
> > I started working on porting prusa-slicer; the main problem I found was
>         There's already a port cad/PrusaSlicer, currently of 2.3.3. There
> are 33 patches - somebody did a lot of work.

Two big problems that are growing in the Open-Source world that comes
from Linux:

1. People think that Open-Source is Linux. No. Linux is only a small
part of Open-Source.

2. Self-incompatible, bleeding edge, enforcing changes, non-maintainable.

:-(

-- 
CeDeROM, SQ7MHZ, http://www.tomek.cedro.info