Re: ZFS failure while installing 12.3-RELEASE
- In reply to: Karl Vogel : "ZFS failure while installing 12.3-RELEASE"
- Go to: [ bottom of page ] [ top of archives ] [ this month ]
Date: Sun, 01 May 2022 19:44:30 UTC
Dear Karl, if you can check: In BIOS setup, the disk interface is set to Sata mode, in the past, changing from Ide to Sata solved problems Change the data cables of the disks, sometimes generic red cables have problems Hope this helps, anything write again, you are welcome El dom., 1 de mayo de 2022 04:15, Karl Vogel <vogelke@pobox.com> escribió: > Greetings, > > I just tried installing 12.3-RELEASE on a box that had been running Oracle > Linux-7.9, and I got all the way through the install with no problems. > I have 5 drives; 2 are identical WD 1-TB, 2 are identical WD 3-TB, > and one Crucial SSD. > > The system found all the drives (including the SSD, to my surprise -- > it was connected via USB cable). I set up a basic mirror on the two WD > 1-TB drives, figuring I'd do the rest of the disk setup later -- I want > a mirrored root filesystem but other things can go on the SSD. > > I got into my setup menu (Intel) and asked to boot from the DVD without > changing the default boot order, which tries the disk first. The install > went fine, but when rebooting from the drive, I saw a ZFS failure: > > Solaris: zroot/ROOT/default: can't open objset 108, error 6. > > It tried again after three seconds, no joy. Reboot into single-user > also fails, and trying rescue from the DVD only shows me the DVD itself; > I don't have a writable root partition. I can do ls and lsdev, and I > see drives like ada0p4 and ada1p4 listed as ZFS, but I'm not sure what > to do next. Some suggestions I've found: > > zpool status > zfs list > > Add the following to loader.conf: > > vfs.zfs.debug="1" > boot_pause="YES" > geom_label_load="YES" > geom_part_gpt_load="YES" > > Tell the system more specifically what to load in /boot/loader.conf: > > vfs.root.mountfrom="zfs:zroot" > > I have another system running FreeBSD-11.4 (no problems) and > /boot/loader.conf contains: > > kern.geom.label.disk_ident.enable="0" > kern.geom.label.gptid.enable="0" > zfs_load="YES" > accf_data_load="YES" > > The last suggestions I found were > > zpool import -fR /mnt zroot > zpool get bootfs zroot > > If the "get" command didn't give me anything, try > > zpool set zroot bootfs zroot > > I did the install under UEFI, and now I can't seem to get to my setup page > at all -- pressing F2 or F10 during boot doesn't work like it used to. > I'm very surprised; FreeBSD installations have always gone smoothly in > the past. > > Any suggestions welcome. Hoping I didn't somehow brick my system. > > -- > Karl Vogel / vogelke AT pobox DOT com / I don't speak for anyone at the > moment > > To make error is human. To propagate error to > all server in automatic way is devops. --If Borat worked in IT > >