[Bug 269668] Hugin assistant locks up during cleaning points

https://bugs.freebsd.org/bugzilla/show_bug.cgi?id=269668

            Bug ID: 269668
           Summary: Hugin assistant locks up during cleaning points
           Product: Ports & Packages
           Version: Latest
          Hardware: amd64
                OS: Any
            Status: New
          Severity: Affects Only Me
          Priority: ---
         Component: Individual Port(s)
          Assignee: ports-bugs@FreeBSD.org
          Reporter: merritt.draney@gmail.com

Created attachment 240243
  --> https://bugs.freebsd.org/bugzilla/attachment.cgi?id=240243&action=edit
Where it gets stuck

I can make hugin work, but it takes some doing. If I run the assistant, it will
find the control points but gets stuck statistically cleaning them. If I x out
I can go into advanced mode and select the images and manually clean the
points. If I try in advanced mode it starts cpfind but immediately locks up. So
I find the points with assistant and switch over to advanced for the rest and
it works. I was using the 2021 version from the pkg and have since upgraded to
2022 with no change. I am running FreeBSD 13.1. I also tried building from
ports to no luck. It works on my Debian partition though.  I even tried it on
GhostBSD with the same locking up result.

Running cpfind once the assistant runs fine along with cpclean with a
previously generated pto file.  

On the hugin sourceforge page, they recommended looking at wxExecute and
associated pages because that is how hugin communicates with the underlining
commands.

Thanks in advance!

-- 
You are receiving this mail because:
You are the assignee for the bug.