Re: HoneyComb first-boot notes
- Reply: Mark Millard via freebsd-arm : "Re: HoneyComb first-boot notes"
- In reply to: Mark Millard via freebsd-arm : "Re: HoneyComb first-boot notes"
- Go to: [ bottom of page ] [ top of archives ] [ this month ]
Date: Tue, 22 Jun 2021 09:20:52 UTC
> >>>> I put an existing FreeBSD Optane into a just delivered > >>>> HoneyComb, put in the RAM and the matching UEFI/ACPI > >>>> image on a microsd card and put the card in the slot. > >>>> I plugged in a USB3 Ethernet dongle, like I use on some > >>>> other systems. Serial console via its USB port for such. > >>>> (Optane instead of video card.) The UEFI/ACPI image was > >>>> extracted from: > >>>> > >>>> https://solid-run-images.sos-de-fra-1.exo.io/LX2k/lx2160a_uefi/lx2160acex7_2000_700_2900_8_5_2_sd_81b4bbe.img.xz > >>>> > >>>> in order to match the RAM and being based on the > >>>> most current vintage at: > >>>> > >>>> https://github.com/SolidRun/lx2160a_uefi/ > >>>> > >>>> It booted. > >>> > >>> Could you share whole dmesg? > >> > >> I've not done a "boot -v" . The below is actually from a > >> captured serial console output. It is lightly edited. I > >> have omitted nearly all loader output (and before). > >> > > > > Thanks for sharing. Have you seen somewhere in output from UEFI (before > > the loader) that "DPAA2 Management Complex initialized"? > > The text "DPAA2" does not occur in the captured output > at all. However, that is my understanding of the expected > status. That's strange because DPAA2 firmware should be included into UEFI built from lx2160a_uefi: https://github.com/SolidRun/edk2-platforms/blob/edk2-stable202102-lx2160acex7/Platform/SolidRun/LX2160aCex7/LX2160aCex7.fdf#L252 I assumed that there might be any output that firmware has been loaded correctly at least. Regards, Dmitry